From the shop floor
Do-it-yourself car guides
Straight, step-by-step instructions for the jobs you can safely do at home — written by the people who fix cars for a living. And honest advice on when a job belongs in a shop.
Maintenance basics
The ten-minute jobs that keep a car healthy and save you a trip.
-
How to Change Your Engine Oil and Filter
Change your own engine oil and filter at home: draining, filter swap, crush washer, correct torque, refilling and checking the dipstick the right way.
-
Replace the Engine Air Filter
Swap your engine air filter in about 15 minutes: how to find the airbox, inspect the old filter, seat the new one correctly and avoid common mistakes.
-
Replace the Cabin Air Filter
Replace your cabin air filter behind the glove box in minutes: find it, get the airflow arrow right, and clear musty AC smells and weak vent airflow.
-
Check and Top Up the Fluids Under the Hood
Check engine oil, coolant, brake fluid, power steering, transmission and washer fluid in 15 minutes, and top them up safely with the right type.
-
Replace Your Wiper Blades
Replace worn wiper blades in minutes: pick the right size, release J-hook and pin connectors, protect your windshield, and know when blades are worn out.
-
Check Tire Pressure and Tread Depth
Check tire pressure the right way with a gauge and measure tread depth with the penny test or a tread gauge so you know exactly when tires need replacing.
-
Rotate Your Tires
Rotate your tires at home with the right pattern for front, rear or all-wheel drive, proper jack stand use, and star-pattern lug nut torque to spec.
-
Change a Flat Tire Safely
Change a flat tire safely: get off the road, use the factory jack correctly, mount the spare and tighten the lug nuts in a star pattern.
-
Jump-Start a Car the Right Way
Jump-start a dead battery safely with jumper cables or a portable jump pack: the correct connection order, where to ground, and what to do afterward.
Brakes & suspension
Stopping, steering and the noises that tell you something is wrong.
-
Replace brake pads and rotors
Step-by-step brake pad and rotor replacement: caliper removal, compressing pistons, rear screw-in calipers, torque, and bedding in new pads.
-
Bleed your brakes
How to bleed or flush brake fluid at home: choosing DOT 3, 4 or 5.1 fluid, the correct bleeding order, two-person and one-person methods, and ABS caveats.
-
Diagnose and replace a wheel bearing
How to tell a bad wheel bearing from tire noise, test it on the car, and replace a bolt-on hub assembly, including axle nut torque and ABS sensor care.
-
Track down clunks and squeaks in your suspension
A practical guide to finding suspension noises: what clunks, squeaks and pops usually mean and how to check links, bushings, joints and mounts yourself.
-
Replace sway bar end links
Fix that clunk over bumps by replacing worn sway bar end links: diagnosis, holding spinning ball studs, seized nuts, and tightening with the bar unloaded.
Engine & electrical
Plugs, belts, coolant, batteries, bulbs and that check-engine light.
-
Replace your car battery
How to test, remove and install a car battery safely: terminal order, hold-downs, AGM and start-stop batteries, and battery registration.
-
Replace spark plugs
Replace your spark plugs the right way: cold engine, clearing the wells, checking gap, the anti-seize debate, correct torque and avoiding cross-threading.
-
Drain, flush and refill your coolant
How to drain, flush and refill engine coolant: choosing a compatible coolant type, mixing with distilled water, and burping air out of the system.
-
Replace the serpentine belt
Replace a worn serpentine belt yourself: inspecting EPDM belts, recording the routing, releasing the tensioner, and checking pulleys before you install.
-
Replace headlight and taillight bulbs
Swap a burned-out headlight, brake light, or turn-signal bulb yourself: find the right bulb number, avoid touching halogen glass, and check your aim.
-
Read your check-engine light with an OBD-II scanner
Plug in an inexpensive OBD-II scanner, read the trouble codes behind your check-engine light, and learn what to do with them before clearing anything.
-
Find and replace a blown fuse
Power outlet, radio, or wipers suddenly dead? Find the right fuse box, read the diagram, test the fuse, and replace it with the exact same amp rating.
Body & paint
What we see every day in the shop — and what you can fix in your driveway.
-
Restore foggy, yellowed headlights
Bring cloudy, yellowed headlight lenses back to clear with wet sanding and polish, then seal them with UV clear coat so the haze doesn't return in months.
-
Touch up paint chips and small scratches
Find your paint code, prep the chip, and dab in factory-matched touch-up paint in thin layers to stop rust and make rock chips nearly disappear.
-
Polish out light scratches and swirl marks
Remove light scratches and swirl marks by hand or with a dual-action polisher without burning through your clear coat: test spots, compounds, pads.
-
Fix small dents at home: what works and what doesn't
An honest look at DIY dent repair: suction pullers, glue-pull kits, the hot-water bumper trick, and the dents you should never try to fix yourself.
-
Replace cracked side-mirror glass
Replace a cracked side mirror without buying the whole housing: remove the old glass safely, move heated-mirror connectors, and snap in the new glass.
-
After a fender bender: what to check before you drive
A practical post-collision checklist: photograph the damage, then check lights, tires, leaks, sensors, and hidden damage before you drive off.